Discontinued item - stock no longer available. To suit: Subaru Levorg VM4 (FB16E (DIT)) Strengthens and increases chassis rigidity without going overboard and compromising the cars inherent handling characteristics. Rigid collars are simple in their shape, clever in their design, made from a aluminium alloy (kept confidential), provides performance is unbelieavble. Designed by Tatsura Ichichma of Spoon Japan. Rigid collar kits are simple to fit and low cost, without affecting the basic geometry of the body. The way the Rigid Collars works is simple. Bolt holes through the chassis panel and sub frame are normally too big as they were designed for ease of production in the factory. When the car leaves the factory, everything is new and tight and the chassis hardly moves. After a while, the bolts become slightly looser and movement between the panels begins. This is why an older vehicles fitted with new bushes, shocks and springs, still doesn't behave like a new car. Rigid Collars are a aluminium washer with a square outer taper that increases adhesion on the thinner flange portion in the middle. This fits between the moving panels and with a properly sized bolt (and bolt hole as part of the Rigid Collar) is crushed into place when tightened, joining the two panels and permanently stopping movement. Rigid Collars cure chassis movement, improve handling, reduce road noise, reduce vibration, improve braking and make the car safer in an accident. SKU / Manufacturer Part Number: 50261-GRB-000 |